标签：
rsync
Usage: /etc/init.d/rsync {start|stop|reload|force-reload|restart|status}
rsync默认配置文件
# defaults file for rsync daemon mode
# start rsync in daemon mode from init.d script?
# only allowed values are "true", "false", and "inetd"
# Use "inetd" if you want to start the rsyncd from inetd,
# all this does is prevent the init.d script from printing a message
# about not starting rsyncd (you still need to modify inetd‘s config yourself).
RSYNC_ENABLE=false
# which file should be used as the configuration file for rsync.
# This file is used instead of the default /etc/rsyncd.conf
# Warning: This option has no effect if the daemon is accessed
# using a remote shell. When using a different file for
# rsync you might want to symlink /etc/rsyncd.conf to
# that file.
# RSYNC_CONFIG_FILE=
# what extra options to give rsync --daemon?
# that excludes the --daemon; that‘s always done in the init.d script
# Possibilities are:
# --address=123.45.67.89 (bind to a specific IP address)
# --port=8730 (bind to specified port; default 873)
RSYNC_OPTS=‘‘
# run rsyncd at a nice level?
# the rsync daemon can impact performance due to much I/O and CPU usage,
# so you may want to run it at a nicer priority than the default priority.
# Allowed values are 0 - 19 inclusive; 10 is a reasonable value.
RSYNC_NICE=‘‘
# run rsyncd with ionice?
# "ionice" does for IO load what "nice" does for CPU load.
# As rsync is often used for backups which aren‘t all that time-critical,
# reducing the rsync IO priority will benefit the rest of the system.
# See the manpage for ionice for allowed options.
# -c3 is recommended, this will run rsync IO at "idle" priority. Uncomment
# the next line to activate this.
# RSYNC_IONICE=‘-c3‘
# Don‘t forget to create an appropriate config file,
# else the daemon will not start.
标签：
原文地址：http://www.cnblogs.com/youxin/p/5074670.html
