标签：
cat /proc/kmsg
<6>[ 2601.360] c0@A7 lm3695_early_suspend 247
<6>[ 2601.380] c1@A7 gp2ap_early_suspend: enabled_sensors = 0
<6>[ 2601.516] c1@A7 disable haptic motor.
<4>[ 2601.537] c0@A7 dhd_set_suspend: force extra Suspend setting
<6>[ 2601.542] c1@A7 leds mx-led: value = 0x0100
<4>[ 2601.553] c0@A7 dhd_get_suspend_bcn_li_dtim beacon=100 bcn_li_dtim=3 DTIM=1 Listen=10
<6>[ 2601.580] c1@A7 gp2ap_set_enable(): old enabled_sensors is 0, new is 2.
<6>[ 2601.600] c1@A15 get_ps_thresholds: ps_near_threshold = 8, ps_far_threshold = 4
<4>[ 2603.165] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2603.180] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2603.195] c3@A7 IRQ155 no longer affine to CPU3
<4>[ 2614.666] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2614.684] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2614.705] c3@A7 IRQ155 no longer affine to CPU3
<3>[ 2620.361] c0@A7 bL_cluster_switch_request: bL switch disabled, exit!
<4>[ 2622.827] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2622.842] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2622.861] c3@A7 IRQ155 no longer affine to CPU3
<6>[ 2624.681] c0@A7 lsm330dlc_acc_enable called stat->enabled = 0
<6>[ 2624.689] c0@A7 mx_hub 18-0043: lsm330dlc_acc_device_power_on called
<6>[ 2624.702] c0@A7 lsm330dlc_acc: hw init start
<6>[ 2624.721] c0@A7 lsm330dlc_acc_hw_init called, read device id 0x33
<6>[ 2624.820] c0@A7 lsm330dlc_acc: hw init done
<6>[ 2626.261] c0@A7 lsm330dlc_acc_disable called
<6>[ 2626.269] c0@A7 mx_hub 18-0043: lsm330dlc_acc_device_power_off called
<6>[ 2631.295] c0@A7 lsm330dlc_acc_enable called stat->enabled = 0
<6>[ 2631.303] c0@A7 mx_hub 18-0043: lsm330dlc_acc_device_power_on called
<6>[ 2631.312] c0@A7 lsm330dlc_acc: hw init start
<6>[ 2631.334] c0@A7 lsm330dlc_acc_hw_init called, read device id 0x33
<6>[ 2631.435] c0@A7 lsm330dlc_acc: hw init done
<3>[ 2631.870] c0@A7 bL_cluster_switch_request: bL switch disabled, exit!
<6>[ 2632.936] c0@A7 lsm330dlc_acc_disable called
<6>[ 2632.939] c0@A7 mx_hub 18-0043: lsm330dlc_acc_device_power_off called
<4>[ 2634.672] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2634.694] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2634.714] c3@A7 IRQ155 no longer affine to CPU3
<3>[ 2637.766] c0@A7 bL_cluster_switch_request: bL switch disabled, exit!
<4>[ 2640.502] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2640.518] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2640.535] c3@A7 IRQ155 no longer affine to CPU3
<6>[ 2645.231] c0@A7 healthd: battery l=90 v=4168 t=34.5 h=2 st=3 c=-250 chg=
<4>[ 2647.271] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2647.286] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2647.299] c3@A7 IRQ155 no longer affine to CPU3
<4>[ 2649.671] c1@A7 IRQ153 no longer affine to CPU1
<4>[ 2649.685] c2@A7 IRQ154 no longer affine to CPU2
<4>[ 2649.699] c3@A7 IRQ155 no longer affine to CPU3
u盘插入
<6>[ 2707.479] c0@A7 scsi0 : usb-storage 2-1:1.0
<5>[ 2708.490] c2@A7 scsi 0:0:0:0: Direct-Access Generic Flash Disk 8.07 PQ: 0 ANSI: 4
<5>[ 2708.510] c2@A7 sd 0:0:0:0: [sda] 16099328 512-byte logical blocks: (8.24 GB/7.67 GiB)
<5>[ 2708.520] c3@A7 sd 0:0:0:0: [sda] Write Protect is off
<5>[ 2708.520] c2@A7 sd 0:0:0:0: Attached scsi generic sg0 type 0
<7>[ 2708.530] c3@A7 sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00
<5>[ 2708.534] c3@A7 sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn‘t support DPO or FUA
<6>[ 2708.559] c3@A7 sda: sda1
<5>[ 2708.575] c1@A7 sd 0:0:0:0: [sda] Attached SCSI removable disk
<3>[ 2708.581] c3@A7 FAT-fs (sda1): bogus number of reserved sectors
<6>[ 2708.586] c3@A7 FAT-fs (sda1): Can‘t find a valid FAT filesystem
<4>[ 2708.876] c0@A7 [test] status=0x20, pending=0x0
<4>[ 2708.880] c0@A7 [test] INTMASK=0x37cf, IDSTS=0x102 IDINTEN=0x103
标签：
原文地址：http://www.cnblogs.com/ahuo/p/5377190.html
