标签：sys sysconfig int start tar figure over bond0 conf
eth0 and eth1, bonded interface is named as bond0, VLAN over bond is named as bond0.402 and a bridge over this VLAN is named as br0./etc/sysconfig/network-scripts/ifcfg-eth0
-----------------------------------------
DEVICE=eth0
ONBOOT=yes
NM_CONTROLLED=no
MASTER=bond0
SLAVE=yes
HWADDR=XX:XX:XX:XX:XX:XX
BOOTPROTO=none
USERCTL=no
/etc/sysconfig/network-scripts/ifcfg-eth1
-----------------------------------------
DEVICE=eth1
ONBOOT=yes
NM_CONTROLLED=no
MASTER=bond0
SLAVE=yes
HWADDR=XX:XX:XX:XX:XX:XX
BOOTPROTO=none
USERCTL=no
/etc/sysconfig/network-scripts/ifcfg-bond0
-----------------------------------------
DEVICE=bonde0
ONBOOT=yes
NM_CONTROLLED=no
USERCTL=no
BOOTPROTO=none
BONDING_OPTS="mode=1 miimon=100"
/etc/sysconfig/network-scripts/ifcfg-bond0.402
----------------------------------------------
DEVICE=bond0.402
ONBOOT=yes
NM_CONTROLLED=no
BOOTPROTO=none
VLAN=yes
BRIDGE=br0
/etc/sysconfig/network-scripts/ifcfg-br0
----------------------------------------
DEVICE=br0
TYPE=Bridge
BOOTPROTO=static
ONBOOT=yes
NM_CONTROLLED=no
IPADDR=X.X.X.X
NETMASK=X.X.X.X
GATEWAY=X.X.X.X
/etc/modprobe.conf so as to load module.alias bond0 bonding
NOTE: RHEL6 does not need above step.
service network restart
Configure a bridge interface over a VLAN tagged bonded interface
标签：sys sysconfig int start tar figure over bond0 conf
原文地址：http://www.cnblogs.com/echo1937/p/6239040.html
