1841 router2 添加 hwic-8a 模块 octal 线缆连接 1841 router2 async 0/0/0 与 1841 router3 console
1841 router2配置如下：
Router>enable
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#interface loopback 0
Router(config-if)#
%LINK-5-CHANGED: Interface Loopback0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up
Router(config-if)#ip address 1.1.1.1 255.255.255.255
Router(config-if)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#show line
Tty Line Typ Tx/Rx A Roty AccO AccI Uses Noise Overruns Int
* 0 0 CTY - - - - 0 0 0/0 -
1 1 AUX 9600/9600 - - - - 0 0 0/0 -
0/0/0 2 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/1 3 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/2 4 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/3 5 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/4 6 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/5 7 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/6 8 TTY 9600/9600 - - - - 0 0 0/0 -
0/0/7 9 TTY 9600/9600 - - - - 0 0 0/0 -
194 194 VTY - - - - 0 0 0/0 -
195 195 VTY - - - - 0 0 0/0 -
196 196 VTY - - - - 0 0 0/0 -
197 197 VTY - - - - 0 0 0/0 -
198 198 VTY - - - - 0 0 0/0 -
Line(s) not in async mode -or- with no hardware support:
10-193
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#line tty 2 9
Router(config-line)#password 888888
Router(config-line)#transport input all
Router(config-line)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#telnet 1.1.1.1 2002
Trying 1.1.1.1 ...Open
User Access Verification
Password: System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fc1)
Cisco 1841 (revision 5.0) with 114688K/16384K bytes of memory.
Readonly ROMMON initialized
Self decompressing the image :
######################### [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 1841 Software (C1841-ADVIPSERVICESK9-M), Version 12.4(15)T1, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Wed 18-Jul-07 04:52 by pt_team
Image text-base: 0x60080608, data-base: 0x6270CD50
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 1841 (revision 5.0) with 114688K/16384K bytes of memory.
Processor board ID FTX0947Z18E
M860 processor: part number 0, mask 49
2 FastEthernet/IEEE 802.3 interface(s)
191K bytes of NVRAM.
63488K bytes of ATA CompactFlash (Read/Write)
Cisco IOS Software, 1841 Software (C1841-ADVIPSERVICESK9-M), Version 12.4(15)T1, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Wed 18-Jul-07 04:52 by pt_team
Press RETURN to get started!
原文地址：http://yimiyinei.blog.51cto.com/10403163/1975449
