码迷,mamicode.com
首页 > 其他好文 > 详细

20-高级路由:OSPF -特殊区域 GRE

时间:2018-07-07 13:46:00      阅读:161      评论:0      收藏:0      [点我收藏+]

标签:byte   隧道   route   cape   段地址   net   icm   图片   分享图片   

一、实验拓扑:
技术分享图片技术分享图片
二、命令部署:
1、R1和R3部署隧道:分别给R1、R3上隧道配地址、设置Tunnel的源地址、目的地址、模式、静态路由
R3(config)#interface tunnel 3
R3(config-if)#ip add 31.1.1.3 255.255.255.0
R3(config-if)#tunnel source 3.3.3.3 可以是环回口地址:
R3(config-if)#tunnel destination 1.1.1.1
R3(config-if)#tunnel mode gre ip
R3#show run int tunnel 3 //查看tunnel的配置
R3#ping 1.1.1.1 source 3.3.3.3 //tunnel的源目地址是否可以ping通

R3(config)#ip route 1.1.1.1 255.255.255.255 13.1.1.1

同理:R1部署Tunnel
R1(config)#interface tunnel 1
R1(config-if)#ip add 31.1.1.1 255.255.255.0
R1(config-if)#tunnel source 1.1.1.1
R1(config-if)#tunnel destination 3.3.3.3
R1(config-if)#tunnel mode gre ip

R1(config)#ip route 3.3.3.3 255.255.255.255 13.1.1.3

2、将Tunnel网段地址到Area 0
R3(config)#router ospf 110
R3(config-router)#network 31.1.1.0 0.0.0.255 area 0

R1(config)#router ospf 110
R1(config-router)#network 31.1.1.0 0.0.0.255 area 0

三、验证:
1、配置验证:
①查看Tunnel配置
R3#show run int tunnel 3
interface Tunnel3
ip address 31.1.1.3 255.255.255.0
tunnel source 3.3.3.3
tunnel destination 1.1.1.1
②Tunnel的源目是否可以Ping通
R3#ping 1.1.1.1 source 3.3.3.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
Packet sent with a source address of 3.3.3.3
!!!!!
③部署静态路由到1.1.1.1,因为不允许将Tunnel的IP地址和源目同时宣告进OSPF,否则将会是Tunnel一会起来,一会挂掉。
R3#show ip route
1.0.0.0/32 is subnetted, 1 subnets
S 1.1.1.1 [1/0] via 13.1.1.1
2、部署完成后,查看R5否有对方路由条目:
R5#show ip route ospf
2.0.0.0/32 is subnetted, 1 subnets
O IA 2.2.2.2 [110/11114] via 35.1.1.3, 00:00:34, FastEthernet0/0
4.0.0.0/32 is subnetted, 1 subnets
O IA 4.4.4.4 [110/11115] via 35.1.1.3, 00:00:34, FastEthernet0/0
24.0.0.0/24 is subnetted, 1 subnets
O IA 24.1.1.0 [110/11114] via 35.1.1.3, 00:00:34, FastEthernet0/0
12.0.0.0/24 is subnetted, 1 subnets
O IA 12.1.1.0 [110/11113] via 35.1.1.3, 00:00:34, FastEthernet0/0
13.0.0.0/24 is subnetted, 1 subnets
O IA 13.1.1.0 [110/2] via 35.1.1.3, 00:05:20, FastEthernet0/0
31.0.0.0/24 is subnetted, 1 subnets
O IA 31.1.1.0 [110/11112] via 35.1.1.3, 00:05:20, FastEthernet0/0

R2#show ip route ospf
35.0.0.0/24 is subnetted, 1 subnets
O IA 35.1.1.0 [110/11113] via 12.1.1.1, 00:02:26, FastEthernet0/0
4.0.0.0/32 is subnetted, 1 subnets
O 4.4.4.4 [110/2] via 24.1.1.4, 00:39:03, FastEthernet1/0
5.0.0.0/32 is subnetted, 1 subnets
O IA 5.5.5.5 [110/11114] via 12.1.1.1, 00:02:26, FastEthernet0/0
13.0.0.0/24 is subnetted, 1 subnets
O IA 13.1.1.0 [110/2] via 12.1.1.1, 00:02:26, FastEthernet0/0
31.0.0.0/24 is subnetted, 1 subnets
O 31.1.1.0 [110/11112] via 12.1.1.1, 00:02:26, FastEthernet0/0

R5#ping 2.2.2.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds:
!!!!!
技术分享图片

20-高级路由:OSPF -特殊区域 GRE

标签:byte   隧道   route   cape   段地址   net   icm   图片   分享图片   

原文地址:http://blog.51cto.com/13856092/2137521

(0)
(0)
   
举报
评论 一句话评论(0
登录后才能评论!
© 2014 mamicode.com 版权所有  联系我们:gaon5@hotmail.com
迷上了代码!