标签：byte 网关 cti host 无法 link status count val
1.添加2块网卡做bond5聚合2.查询，配置虚拟网卡 ，根据自己的网关配置虚拟网关和dns，ip自定义
[root@localhost ~]# nmcli dev
[root@localhost ~]# nmcli connection add type bond mode balance-tlb con-name bond5 ifname bond5 ipv4.method manual ipv4.addresses 192.168.56.12/24 ipv4.gateway 192.168.56.2 ipv4.dns 192.168.56.2
连接“bond5”(e6039f16-d78e-4fdd-82ca-b4490a40d9d3) 已成功添加。
[root@localhost ~]# nmcli dev
设备 类型 状态 连接
bond5 bond 连接的 bond5
3.将物理网卡连接至bond5
[root@localhost ~]# nmcli connection add type bond-slave con-name bond5-slave0 ifname ens38 master bond5
[root@localhost ~]# nmcli connection add type bond-slave con-name bond5-slave1 ifname ens39 master bond5
连接“bond5-slave0”(5e15186b-4fc9-450d-9095-bcbc553812ad) 已成功添加。
[root@localhost ~]# nmcli dev
4.查看bond信息
[root@localhost ~]# cat /proc/net/bonding/bond5
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: transmit load balancing
Primary Slave: None
Currently Active Slave: ens38
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: ens38
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:0c:29:ce:d7:d6
Slave queue ID: 0
[root@localhost ~]# ping 192.168.56.12
PING 192.168.56.12 (192.168.56.12) 56(84) bytes of data.
64 bytes from 192.168.56.12: icmp_seq=1 ttl=64 time=0.068 ms
64 bytes from 192.168.56.12: icmp_seq=2 ttl=64 time=0.031 ms
64 bytes from 192.168.56.12: icmp_seq=3 ttl=64 time=0.045 ms
断开
[root@localhost ~]# nmcli device disconnect ens38
[root@localhost ~]# ping 192.168.56.12 当可ping通
激活
[root@localhost ~]# nmcli device connect ens38
成功用 ‘ens38‘ 激活了设备 ‘5e15186b-4fc9-450d-9095-bcbc553812ad‘。
标签：byte 网关 cti host 无法 link status count val
原文地址：http://blog.51cto.com/13859004/2144578
