VRRP 配置

标签：.com   png   bat   images   efault   virtual   原因   process   oss   

思路：
1.在终端处配置好IP、DNS、子网掩码
2.在每台交换机处配置好创建vlan10 20
3.在交换机sw1、sw2、sw3每个接口处用accress
配置
4.配置vrrp：
SW1:
vlan batch 10 20
int Ethernet0/0/1
port link-type access
port default vlan 10
int Ethernet0/0/2
port link-type access
port default vlan 10
int Ethernet0/0/3
port link-type trunk
port trunk allow-pass vlan 2 to 4094
SW1-GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2 to 4094

SW2：
vlan batch 10 20
interface GigabitEthernet0/0/3
port link-type trunk
port trunk allow-pass vlan 2 to 4094
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2 to 4094

     interface Vlanif20
 ip address 192.168.20.253 255.255.255.0
 vrrp vrid 20 virtual-ip 192.168.20.254
 vrrp vrid 20 priority 200
 vrrp vrid 20 preempt-mode timer delay 10
 vrrp vrid 20 track interface 
               GigabitEthernet0/0/1 reduced 150 
 interface GigabitEthernet0/0/1
 port link-type access
 port default vlan 12

SW3:
VLAN BATCH 10 20
interface GigabitEthernet0/0/3
port link-type trunk
port trunk allow-pass vlan 2 to 4094

      interface Vlanif20
 ip address 192.168.20.252 255.255.255.0
 vrrp vrid 20 virtual-ip 192.168.20.254

 R1：
 interface GigabitEthernet0/0/0
 ip address 192.168.12.2 255.255.255.0 

 int g0/0/1
 ip address 192.168.4.254 24  
 ip route-static 192.168.20.0 24 192.168.23.1

     后面还有在路由和交换机SW2 、SW3 分别配置下一跳地址，但是由于时间原因所以没有补全，请凉解！！

VRRP 配置

标签：.com   png   bat   images   efault   virtual   原因   process   oss   

原文地址：https://blog.51cto.com/14302936/2384220