码迷,mamicode.com
首页 > 其他好文 > 详细

2019.5 sigfox test

时间:2019-05-31 21:52:38      阅读:109      评论:0      收藏:0      [点我收藏+]

标签:data   test   sign   comm   store   connect   turn   nal   and   

 Test equipment

1 test fixture  (provide by  PIE)

2 Spectrum Analyzer (e.g E4405B)

3.Vector Signal Generator (e.g E4438C)

4.3dB power splitter combiner

5.898/902/920MHz antenna

6.RF cable x 3

7.PC and Serial port line (3.3V)

8.Sigfox Module :WISOL / WSSFM10R1AT 

RF Specifications :

技术图片

The instrument connection

 技术图片

Spectrum Analyzer Setting:

技术图片

Sigfox serial port Settings

BaudRate Setting: 9600, 8N1, all AT command send to product has to be ended by ‘\r’ (CR)

 

TX test:

1 put the gold sample into the test fixture,measure Power and RSSI, and store it as calibration data 

2 sending  ‘’AT$DR? ‘’  to product

3 sending   Tx on command (AT$CW=xxxxx,m,n)

4 Enter  :Spectrum Analyzer marker peak search  and recording the power and frequency

5 Calculate the frequency PPM

技术图片

6 sending  Tx off command 

7 test  ok

 

RX test

 1 Vector Signal Generator Setting:

技术图片

 

 2 Send Rx start command to the product: AT$TM=3,10. After sending this command, the product will not receive any command in the receiving mode, until 10 seconds later, the product will be returned to the product

 3  Signal generator: RF on  (after about ten seconds )

 4 Trigger Signal Generator  sending  the data once

5 receive data  (RX data and RSSI)

6 Signal generator :RF Off

---------------------------------------------------

 

2019.5 sigfox test

标签:data   test   sign   comm   store   connect   turn   nal   and   

原文地址:https://www.cnblogs.com/huangbaobaoi/p/10957497.html

(0)
(0)
   
举报
评论 一句话评论(0
登录后才能评论!
© 2014 mamicode.com 版权所有  联系我们:gaon5@hotmail.com
迷上了代码!