openwrt Adding a new patch

To add a completely new patch to an existing package example start with preparing the source directory:

For host-side packages, you may want to detail the make target:

This unpacks the source tarball and prepares existing patches as quilt patch series (if any). The verbose output will show where the source got extracted.

Change to the prepared source directory.

Note : It can happen that you need to go one level lower as the source is extracted in build_dir/target-*/BUILD_VARIANT/example-* . This happens when multiple build variants of a package are defined in the Makefile.

Apply all existing patches using quilt push.

Create a new, empty patch file with the quilt new command:

• The name should start with a number, followed by a hyphen and a very short description of what is changed
• The chosen number should be higher than any existing patch - use quilt series to see the list of patches
• The patch file name should be short but descriptive

After creating the empty patch, files to edit must be associated with it. The quilt add command can be used for that - once the file got added it can be edited as usual.
A shortcut for both adding a file and open it in an editor is the quilt edit command:

• src/main.c gets added to 010-main_code_fix.patch
• The file is opened in the editor specified with EDITOR in .quiltrc

Repeat that for any file that needs to be edited.

After the changes are finished, they can be reviewed with the quilt diff command.

If the diff looks okay, proceed with quilt refresh to update the 010-main_code_fix.patch file with the changes made.

Change back to the toplevel directory of the buildroot.

To move the new patch file over to the buildroot, run update on the package:

Finally rebuild the package to test the changes:

If problems occur, the patch needs to be edited again to solve the issues. Refer to the section below to learn how to edit existing patches.