标签：
方法一：用同一个定时器的3路通道能输出同频不同占空比的pwm;但是他们输出的顺序一定是一样的，因为他们用的是同一个计数器
如果要输出3路不同顺序的PWM必须使用3个定时器
例子：
void Tim1_Configuration(void)
{
TIM_TimeBaseInitTypeDef TIM_TimeBaseStructure;
TIM_OCInitTypeDef TIM_OCInitStructure;
GPIO_InitTypeDef GPIO_InitStructure;
/* PA9设置为功能脚(PWM) */
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
RCC_APB2PeriphClockCmd(RCC_APB2Periph_TIM1,ENABLE);
TIM_DeInit(TIM1);
/*TIM1时钟配置*/
TIM_TimeBaseStructure.TIM_Prescaler = 71; //预分频(时钟分频)72M/72=1000K
TIM_TimeBaseStructure.TIM_CounterMode = TIM_CounterMode_Up; //向上计数
TIM_TimeBaseStructure.TIM_Period = 660; //装载值 1000k/660=1515hz
TIM_TimeBaseStructure.TIM_ClockDivision = TIM_CKD_DIV1;
TIM_TimeBaseStructure.TIM_RepetitionCounter = 0x0;
TIM_TimeBaseInit(TIM1,&TIM_TimeBaseStructure);
/* Channel 2 Configuration in PWM mode */
TIM_OCInitStructure.TIM_OCMode = TIM_OCMode_PWM2; //PWM模式2
TIM_OCInitStructure.TIM_OutputState = TIM_OutputState_Enable; //正向通道有效
TIM_OCInitStructure.TIM_OutputNState = TIM_OutputNState_Disable;//反向通道无效
TIM_OCInitStructure.TIM_Pulse = 430; //占空时间
TIM_OCInitStructure.TIM_OCPolarity = TIM_OCPolarity_Low; //输出极性 有效电平
TIM_OCInitStructure.TIM_OCNPolarity = TIM_OCNPolarity_High; //互补端的极性
TIM_OCInitStructure.TIM_OCIdleState = TIM_OCIdleState_Set;
TIM_OCInitStructure.TIM_OCNIdleState = TIM_OCIdleState_Reset;
TIM_OC2Init(TIM1,&TIM_OCInitStructure); //通道1
/* TIM1 counter enable */
// TIM_Cmd(TIM1,ENABLE);
/* TIM1 Main Output Enable */
//TIM_CtrlPWMOutputs(TIM1,ENABLE);
}
PWM占空比高低电平设置：PWM模式1时：CNT（计数器）<TIM_Pulse为有效电平，否则为无效电平;PWM模式2, CNT<TIM_Pulse为无效电平，否则为有效电平
方法二：当定时器资源不足时，用一个定时器，在中断中通过3个IO口模拟出3路PWM
标签：
原文地址：http://www.cnblogs.com/child123/p/4581533.html
